Upgrading a memory module

Your machine has a dual in-line memory module (DIMM). Use this memory module slot to install additional memory.

Order information is provided for additional memory module. (See Available accessories.)

Installing a memory module

  1. Turn the machine off and unplug all cables from the machine.

  2. Grasp the control board cover and remove it.

  3. Remove the new memory module from its bag.

  4. Holding the memory module by the edges, align the memory module on the slot at about a 30-degree tilt. Make sure that the notches of the module and the grooves on the slot fit each other.

    [Note]

    The notches and grooves illustrated above may not match those on an actual memory module and its slot.

  5. Press the memory module into the slot with care until you hear a ‘click’.

    [Caution]

    Do not press the memory module strongly or the module may be damaged. If the module does not seem to fit into the slot properly, carefully try the previous procedure again.

  6. Replace the control board cover.

  7. Reconnect the power cord and machine cable and turn the machine on.