Installing the driver locally

A locally connected machine is a machine directly attached to your computer using the cable. If your machine is attached to a network, skip the following steps below and go on to installing a network connected machine’s driver (see Advanced Guide).

[Note]

  • If you are a Macintosh, Linux, or Unix OS user, refer to the Advanced guide.

  • The installation window in this User’s Guide may differ depending on the machine and interface in use.

  • Selecting Advanced Installation > Custom Installation allows you to choose which programs to install.

  • Only use a USB cable no longer than 3 meters (118 inches).

Windows

  1. Make sure that the machine is connected to your computer and powered on.

    [Note]

    If the “Found New Hardware Wizard” appears during the installation procedure, click Cancel to close the window.

  2. Insert the supplied software CD into your CD-ROM drive.

    The software CD should automatically run and an installation window will appear.

  3. Select Install Now.

  4. Read License Agreement, and select I accept the terms of the License Agreement. Then, click Next.

  5. Follow the instructions in the installation window.